 |
Synced immediately with my Panasonic ptae 8000u projector. The image is astounding. We have seen 3D movies in the theater but never enjoyed it this much. The active glasses make a big difference, especially on a 100 inch screen with a THX sound system. Big fan of 3D now,so is my wife
Verified purchase: Yes | Condition: Refurbished
These are good when they work. Unfortunately, they have rechargeable LiFe or LiPo batteries that will balloon and cease working when left unused for so long, including the bulk ones you see on this site that have been sitting in a warehouse for who-knows-how-long. Even if they were maintained and still keep a charge, these batteries will still need to be replaced at some point. While it it _is_ possible to replace the battery, there are a number of caveats. First, these glasses were not designed to be disassembled. There are 6 screws, but the plastic is mostly held together with clips and glue, with the two central corners at the nose having clips that are glued (these are the worst to separate). On top of that, you have to be very mindful not to pull too hard when separating those two joints, because the battery is adhered to the inner plastic, while the PCB is adhered to outer/front plastic. In my case, the battery leads ripped cleanly off the PCB; however, if they don't, you could risk ripping the solder pads off the PCB or ripping the PCB off of the front plastic and damaging the connections to the LCDs. If at all possible, I recommend holding open the plastic at the top just enough to reach in with some slim snips and cut the battery leads before attempting to pry off those two glued clips. Now comes the fun part: finding a replacement battery and soldering it in. I wasn't able to find any exact replacements after a day of searching, but the TinyCircuits ASR00011 (as recommended to me on AVS Forum) appears to be close enough. I have one on order and will update this review once I've attempted installation.Read full review
Verified purchase: Yes | Condition: Pre-owned
These are Sony's they're not as good as the ones as that came with my SONY 3D TV there's a on and off slide switch you have to activate before you put in the power cord , slide this to the on button and then you have to turn Slide the switch to the on position before you charge the directions are not visual they don't show you where the top of the nose of the Bridge is where you need to "plug it in to charge" it and then make sure you slide the on button to have it charged I know Sony is not thinking of the future of these 3D glasses ..... In Enclosing Sony needs to make a better 3D glasses.
Verified purchase: Yes | Condition: Pre-owned
I've bought three pair of these, None of them charge anymore. The battery goes bad after a couple of years. My advice would be to buy glasses with replaceable batteries, since the rechargeable ones die, and won't recharge after a couple of years.
Verified purchase: Yes | Condition: New
Glasses must be used while TV is in HDMI mode, that means you cannot stream, or use the TV in 3-D mode if you are not using an HDMI input for the glasses to connect
Verified purchase: Yes | Condition: Refurbished
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in 3D TV Glasses & Accessories
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Save on 3D TV Glasses & Accessories
Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- You may also like
