Current slide {CURRENT_SLIDE} of {TOTAL_SLIDES}- Best Selling in Spur Gears
They are an inexpensive upgrade but you will need to de-burr them they are not exactly drop in and good to go. That said some quality time with a small file de-burring the rough edges and they are an incredible upgrade to the plastic gears I had! I highly recommend them they just need some hand work. What I received had very sharp edges and I did cut a finger on a burr. At this price point I do not mind the required hand finishing to smooth the sharp edges!
Verified purchase: Yes | Condition: New
I think the gears will work fine. The shipping was quick considering it came all the way from China. Shipping took about three weeks. Quality of the gears are very good. The shipping package could’ve been better. Gears came in a little plastic bag. But the bag was intact, in good shape. I’m going to use these in a 7 x 16 lathe. Grizzly G0765.
Verified purchase: Yes | Condition: New
The gears seem to be well made and finished. No chipped teeth or any other defects. They seem to be the same as the ones sold by Little Machine Shop for $60. I bought these to replace the plastic gears on my Grizzly G0576 (7x14) lathe. I have not used the gears yet, since I am also replacing the the headstock bearings. I am sure they will be a big improvement - gears that is. I had to wait a few weeks but shipping was free. Aii-in-all not a bad deal.
Verified purchase: Yes | Condition: New
I haven not installed the gears yet but they appear to have an adequate finish (no file clean-up required) and they appear to be ready to install. It's nice to have the original gear teeth ratios too. Not all gears sold maintain the original reduction ratios.
Verified purchase: Yes | Condition: New
Good enough for this price
Verified purchase: Yes | Condition: New